HOUSE MANUAL

This manual used 3D drawing to show you how to assemble the bird house, make sure you are have mask, goggle and gloves for wood work before get into workshop.

Please notice that each size of each parts, and follow the process to finish this special work. Enjoy!

Introduction

PARTS LIST

EQUIPMENT

·Fixator*6

Living area:

·Roof
·Front board with a
circular entrance
·Main wall*3
·Base
·Rest stick*4

Collection system:

·Rest board(For keep clean the area near the handle)
·Iron grid board with 2 stick to fix
·Collection board with 2 stick to fix
·A handle

·Mask and goggle
·Sketch paper*10A3
·Pen
·Eraser
·Shear
·Spray adhesive
·Nails
·Hammer
·Plywood 600*500*30mm*8
·Iron gird 250*200mm
·Table saw
·Sanders machine
·Bandsaws

Number of the parts

Size of the parts

WORKSHIOP PART

Step 1

Print each part on paper, cut out each part, and stick part paper on the plywood board with spray adhesive.

Step 2

Put the board on table saw, wear your mask and goggle,then you can press the start button and cut with carefully. Trips: You should follow the line but don’t cut on the line, save some space to sanding on next step.

Step 3

Now use the sanders machine,keeping wear your mask and goggle, press the start button, and push the board to the working bar by slow. When sanding the small part you should use the hand sanding bar.

Step 4

After finish all the parts,is time to composing they. Fix each part with nails.

SET UP ON THE TREE

·Point out each locate trees on the map,use ladder get to the branch, and the height should between 2 and 5 meter.

Roof and collection board can be move, so that people can check the house inside.

Excrement will through the iron grid and drop on the collection board